Cisco Cisco Packet Data Interworking Function (PDIF)
ACS Rulebase Configuration Mode Commands
override-control ▀
Command Line Interface Reference, StarOS Release 17 ▄
739
override-control
This command enables or disables Override Control feature. The Diameter capability exchange message should indicate
support for Override control feature when this CLI command is enabled.
support for Override control feature when this CLI command is enabled.
Important:
Override Control is a license-controlled feature. A valid feature license must be installed prior to
configuring this feature. Contact your Cisco account representative for more information.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
[ default | no ] override-control
default
Configures this command with its default setting.
Default: Disabled
Default: Disabled
no
If previously enabled, disables Override control in the current rulebase.
Usage
Use this command to enable or disable Override Control feature. This feature is available at the rulebase level
and is license controlled. The Diameter capability exchange message should indicate support for Override
control feature when this CLI command is enabled.
Inheritance feature does not support overwriting parameters at Rule level and charging action level and
supports exclusion of only one rule. In order to provide this flexibility and also have a generic capability on
chassis, Override Control feature is introduced. This feature will define a set of custom AVPs that will enable
the PCRF to override charging and policy parameters for all rules (wildcard) or a specified set of rules or
charging actions.
The override values should be sent by PCRF over Gx using the custom AVPs. Override Control provides this
capability while addressing the limitations with Inheritance feature like rule level control, charging action
level control, exclusion of more than one rule, different override values to be specified for a subscriber, etc.
So, the Override Control feature will replace the Inheritance feature.
and is license controlled. The Diameter capability exchange message should indicate support for Override
control feature when this CLI command is enabled.
Inheritance feature does not support overwriting parameters at Rule level and charging action level and
supports exclusion of only one rule. In order to provide this flexibility and also have a generic capability on
chassis, Override Control feature is introduced. This feature will define a set of custom AVPs that will enable
the PCRF to override charging and policy parameters for all rules (wildcard) or a specified set of rules or
charging actions.
The override values should be sent by PCRF over Gx using the custom AVPs. Override Control provides this
capability while addressing the limitations with Inheritance feature like rule level control, charging action
level control, exclusion of more than one rule, different override values to be specified for a subscriber, etc.
So, the Override Control feature will replace the Inheritance feature.