Cisco Cisco Packet Data Interworking Function (PDIF)
S-GW Service Configuration Mode Commands
pgw-fteid-in-relocation-cs-rsp ▀
Command Line Interface Reference, StarOS Release 17 ▄
8625
pgw-fteid-in-relocation-cs-rsp
Controls the sending of the PGW Fully Qualified Tunnel Endpoint Identifier (FTEID) for relocation Create Session
Response procedures with an S-GW change.
Response procedures with an S-GW change.
Product
S-GW
Privilege
Administrator, Security Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
[no] pgw-fteid-in-relocation-cs-rsp
no
Disables the sending of the P-GW FTEID in Create Session Response procedures where there is an S-GW
relocation change. This is the default setting.
relocation change. This is the default setting.
pgw-fteid-in-relocation-cs-rsp
Enables the sending of the P-GW FTEID in Create Session Response procedures where there is an S-GW
relocation change.
relocation change.
Usage
Use this command to control the sending of the PGW Fully Qualified Tunnel Endpoint Identifier (FTEID) for
relocation Create Session Response procedures with an S-GW change. For backward compatibility with
earlier 3GPP release peer nodes requiring the P-GW FTEID in the Create Session Response procedures, this
configurable can be enabled.
relocation Create Session Response procedures with an S-GW change. For backward compatibility with
earlier 3GPP release peer nodes requiring the P-GW FTEID in the Create Session Response procedures, this
configurable can be enabled.
Example
To enable the sending of the FTEID for relocation Create Session REsponse procedures with an S-GW
change..
change..
pgw-fteid-in-relocation-cs-rsp