Cisco Cisco Packet Data Gateway (PDG)
Card Configuration Mode Commands
service-type ▀
Command Line Interface Reference, StarOS Release 16 ▄
2093
service-type
Configures the type of service that the CLC or CLC2 line card will support. (ASR 5000 only)
Important:
Supported in software releases 8.1 and higher.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Card Configuration
configure > card card_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-card- slot_number)#
Syntax
service-type { frame-relay | mtp2| multi-service | pwe3-cesopsn | unspecified } [ -
noconfirm ]
noconfirm ]
default service-type [ -noconfirm ]
default
Returns the card configuration to unspecified.
frame-relay
Configures the card to operate in Frame Relay service mode.
mtp2
Important:
MTP2 functionality is not yet supported.
Enables MTP2 type service to support narrowband transmissions.
multi-service
Enables path-level service for multiple simultaneous services (such as frame-relay and mtp2) to run over a
single port. For additional information, see the Channelized Port Configuration Mode Commands chapter
single port. For additional information, see the Channelized Port Configuration Mode Commands chapter
pwe3-cesopsn
Important:
pwe3-cesopsn
functionality has been replaced by
mtp2
.