Cisco Cisco Packet Data Interworking Function (PDIF)
Call Control Profile Configuration Mode
▀ egtp
▄ Command Line Interface Reference, StarOS Release 16
1896
egtp
Configures the type of PLMN sent in either the user location information (ULI) IE or the Serving Network IE.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Call Control Profile Configuration
configure > call-control-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-call-control-profile-profile_name)#
Syntax
egtp network-sharing-plmn { serving-network { use-common-plmn | use-selected-plmn | use-
ue-plmn } | uli { use-common-plmn | use-selected-plmn | use-ue-plmn } }
ue-plmn } | uli { use-common-plmn | use-selected-plmn | use-ue-plmn } }
remove egtp network-sharing-plmn { serving-network | uli }
remove
Erases the IE choice from the callcontrol profile configuration.
use-common-plmn
Instructs the SGSN to identify the Common PLMN for the shared network.
use-selected-plmn
Instructs the SGSN to identify the Selected PLMN for the shared network.
use-ue-plmn
Instructs the SGSN to identify the UE selected PLMN that is available in the shared network.
Usage
The SGSN supports location change reporting on the S4 interface, when requested by the P-GW, using a ULI
IE in GTPv2 messages. When the network sharing feature is enabled the operator can determine which
PLMN to send to the P-GWin the ULI IE and Serving Network IE. The command can be issued multiple
times to configure the PLMN type for each IE.
The selections made for this configuration must match those configured for the call control profile’s GTP
configuration.
This command can only be used if network sharing is enabled and the appropriate “Location-reporting in
connected-mode“ feature license is installed. For details, check with your Cisco Representative.
IE in GTPv2 messages. When the network sharing feature is enabled the operator can determine which
PLMN to send to the P-GWin the ULI IE and Serving Network IE. The command can be issued multiple
times to configure the PLMN type for each IE.
The selections made for this configuration must match those configured for the call control profile’s GTP
configuration.
This command can only be used if network sharing is enabled and the appropriate “Location-reporting in
connected-mode“ feature license is installed. For details, check with your Cisco Representative.
Example
Configure the ue-plmn type PLMN to be sent in the Serving Network IE:
egtp network-sharing-plmn serving-network ue-plmn