Cisco Cisco Packet Data Interworking Function (PDIF)
Card Configuration Mode Commands
▀ framing
▄ Command Line Interface Reference, StarOS Release 16
2082
framing
Configures the type of framing to be used for the signaling generated on a specific line card. (ASR 5000 only)
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Card Configuration
configure > card card_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-card- slot_number)#
Syntax
framing { ethernet | sdh [ ds1 | e1 ] [ ss-bits ] | sonet [ ds1 | e1 ] | unspecified } [
-noconfirm ]
-noconfirm ]
default framing [ -noconfirm ]
default
Resets the framing generated by the card to the default for the particular card type.
ethernet
Configures the system to use Ethernet framing for this line card. This type of framing can only be used on an
Ethernet card.
Default: Ethernet framing type is the default for an Ethernet line card.
Ethernet card.
Default: Ethernet framing type is the default for an Ethernet line card.
Important:
Using this keyword with an OLC/OLC2 or CLC/CLC2 takes the card offline.
sdh [ ds1 | e1 ] [ ss-bits ]
Configures the system to use SDH signal framing for either an OLC/OLC2 or CLC/CLC2 line card in an
SGSN.
SGSN.
Important:
Using this keyword with an Ethernet line card takes the line card offline.
In releases 8.1 and higher, you can also set the type of signaling path for a CLC2.
ds1
- configures the card to support a DS1/T1.
e1
- configures the card to support an E1. This is the default for SDH.
ss-bits
- enables/disables use of ss-bits (per ITU 1997 G.783 specification) for SDH configured line card.