Cisco Cisco Packet Data Interworking Function (PDIF)
Card Configuration Mode Commands
▀ header-type
▄ Command Line Interface Reference, StarOS Release 16
2084
header-type
Defines the size of the header frame for Frame Relay transmissions over a CLC or CLC2 channelized line card. (ASR
5000 only)
5000 only)
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Card Configuration
configure > card card_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-card- slot_number)#
Syntax
header-type header-size [ -noconfirm ]
default header-type [ -noconfirm ]
default
Resets the configuration to the default header size of 2-bytes.
header-size
Sets the size, number of bytes, for the header frame.
header-size
must be either 2-bytes or 4-bytes.
-noconfirm
Executes the command without additional prompting for command confirmation.
Usage
Use this command to set the size of the header frame for Frame Relay messages emanating from the line card.
The size (2-bytes or 4-bytes) determines the amount of information that can be transmitted in that first
information frame.
The size (2-bytes or 4-bytes) determines the amount of information that can be transmitted in that first
information frame.
Important:
Not supported on all platforms
Example
Set the header to the smallest size.
header-type 2-byte