Cisco Cisco Packet Data Interworking Function (PDIF)
HNB-GW Administration Guide, StarOS Release 17 ▄
85
Chapter 3
HNB-GW Service Configuration Procedures
This chapter is meant to be used in conjunction with the other chapters that describes the information needed to
configure the system to support HNB-GW functionality for use in HNB access networks.
configure the system to support HNB-GW functionality for use in HNB access networks.
It is recommended that you identify the options from the previous chapters that are required for your specific
deployment. You can then use the procedures in this chapter to configure those options.
deployment. You can then use the procedures in this chapter to configure those options.
This chapter describes following:
Important:
At least one packet card must be made active prior to service configuration. Information and
instructions for configuring the packet cards to be active can be found in the Configuring System Settings chapter of the
System Administration Guide.
System Administration Guide.
Caution:
While configuring any base-service or enhanced feature, it is highly recommended to take care of
conflicting or blocked IP addresses and port numbers for binding or assigning. In association with some service steering
or access control features, like Access Control List configuration, use of inappropriate port number may result in
communication loss. Refer respective feature configuration document carefully before assigning any port number or IP
address for communication with internal or external network.
or access control features, like Access Control List configuration, use of inappropriate port number may result in
communication loss. Refer respective feature configuration document carefully before assigning any port number or IP
address for communication with internal or external network.