Cisco Cisco Packet Data Gateway (PDG) Prospecto
MME Service Configuration Mode Commands
policy service-request ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
6979
policy service-request
Configure the behavior of the MME when an initial context setup failure is received during a service request or
extended service request procedure.
extended service request procedure.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
policy service-request initial-context-setup-failure s1ap-cause-code-group group_name
action idle-mode-entry
action idle-mode-entry
default policy service-request initial-context-setup-failure
default
Returns the command to its default behavior, where it detaches the UE when an initial context setup failure is
received during a service request or extended service request procdure.
received during a service request or extended service request procdure.
initial-context-setup-failure s1ap-cause-code-group group_name
action idle-mode-
entry
Configures the behavior of the MME when an initial context failure is received from the eNodeB during a
service request or extended service request. By default, the MME detaches the UE. This command configures
the MME to move the UE to IDLE MODE instead.
service request or extended service request. By default, the MME detaches the UE. This command configures
the MME to move the UE to IDLE MODE instead.
group_name
: Specify the name of a preconfigured Cause Code Group. The MME takes the configured
action to move the UE to IDLE MODE when the cause code returned from the eNodeB matches any of the
cause codes defined in this Cause Code Group.
Refer to the
cause codes defined in this Cause Code Group.
Refer to the
cause-code-group
command in the LTE Policy Configuration Mode Commands chapter, and
the
class
command in the S1AP Cause Code Configuration Mode Commands chapter for more information.
action idle-mode-entry
: Configures the MME to move the UE to IDLE MODE when the cause code
returned from the eNodeB matches any of the cause codes in the specified S1-AP cause code group.
Usage
Use this command to configure the behavior of the MME when an initial context setup failure is received
during a service request or extended service request procedure.
during a service request or extended service request procedure.
Example
The following command configures the MME to detach the UE when an initial context failure occurs and the
eNodeB returns a cause code which matches any of the cause codes configured in the idle S1-AP cause code
group:
eNodeB returns a cause code which matches any of the cause codes configured in the idle S1-AP cause code
group: