Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Ethernet Port Configuration Mode Commands
▀ threshold rx-utilization
▄ Cisco ASR 5x00 Command Line Interface Reference
3554
threshold rx-utilization
Configures thresholds for receive port utilization.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
threshold rx-utilization high_thresh [ clear low_thresh ]
high_thresh
Specifies the high threshold receive port utilization percentage that must be met or exceeded within the
polling interval to generate an alert or alarm. The percentage is expressed as an integer from 0 through 100.
Default: 80
polling interval to generate an alert or alarm. The percentage is expressed as an integer from 0 through 100.
Default: 80
clear
Allows the configuration of the low threshold.
low_thresh
Specifies the low threshold receive port utilization percentage that maintains a previously generated alarm
condition. If the utilization percentage falls below the low threshold within the polling interval, a Clear Alarm
will be generated. The percentage is expressed as an integer from 0 through 100. Default: 80
condition. If the utilization percentage falls below the low threshold within the polling interval, a Clear Alarm
will be generated. The percentage is expressed as an integer from 0 through 100. Default: 80
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Receive port utilization thresholds generate alerts or alarms based on the utilization percentage of each
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis.
configured port in relation to data received during the specified polling interval. This threshold is configured
on a per-port basis.
Important:
Ports configured for half-duplex do not differentiate between data received and data transmitted.
Therefore, to avoid redundant alarms, it is recommended that only the receive or transmit utilization threshold be
configured.
configured.