Cisco Cisco Packet Data Interworking Function (PDIF) Prospecto
Ethernet Port Configuration Mode Commands
▀ threshold tx-utilization
▄ Cisco ASR 5x00 Command Line Interface Reference
3556
threshold tx-utilization
Configures thresholds for transmit port utilization.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
threshold tx-utilization high_thresh [ clear low_thresh ]
high_thresh
The high threshold transmit port utilization percentage that must be met or exceeded within the polling
interval to generate an alert or alarm. The percentage is expressed as an integer from 0 through 100. Default:
80
interval to generate an alert or alarm. The percentage is expressed as an integer from 0 through 100. Default:
80
clear
Allows the configuration of the low threshold.
low_thresh
The low threshold transmit port utilization percentage that maintains a previously generated alarm condition.
If the utilization percentage falls below the low threshold within the polling interval, a clear alarm will be
generated. The percentage is expressed as an integer from 0 through 100. Default: 80
If the utilization percentage falls below the low threshold within the polling interval, a clear alarm will be
generated. The percentage is expressed as an integer from 0 through 100. Default: 80
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Transmit port utilization thresholds generate alerts or alarms based on the utilization percentage of each
configured port in relation to data transmitted during the specified polling interval. This threshold is
configured on a per-port basis.
configured port in relation to data transmitted during the specified polling interval. This threshold is
configured on a per-port basis.
Important:
Ports configured for half-duplex do not differentiate between data received and data transmitted.
Therefore, to avoid redundant alarms, it is recommended that only the receive or transmit utilization threshold be
configured.
configured.
Alerts or alarms are triggered for transmit port utilization based on the following rules: