Cisco Cisco Packet Data Interworking Function (PDIF) Notas De La Versión

Descargar
Página de 678
  S-GW Changes in Release 15.0 
S-GW Enhancements for March 30, 2014  ▀   
 
Cisco ASR 5x00 Release Change Reference  ▄  
 
   
547 
Previous Behavior:  CSR with oi=0 during a handover was rejected if a dedicated bearer with IE Bearer context to be 
removed was present. 
New Behavior:  The Create Session Request with oi=0 during a handover is now accepted by the system. 
CSCum65866 - cli required to control pgw fteid in relocation create session 
response.  
Applicable Products: S-GW 
Feature Changes 
Control of P-GW FTEID in Relocation with S-GW Change
 
The S-GW software has been enhanced to support control of the P-GW Fully Qualified Tunnel Endpoint Identifier 
(FTEID) for relocation Create Session Response procedures with an S-GW change. For backward compatibility with 
earlier 3GPP release peer nodes requiring P-GW FTEID in the Create Session Response procedures, this configurable 
can be enabled. 
Command Changes 
pgw-fteid-in-relocation-cs-rsp
 
This new command in S-GW Service Configuration Mode enables the S-GW to send the P-GW FTEID in Create 
Session Response procedures where there is an S-GW relocation change. By default, this setting is disabled. 
configure 
  context context_name 
     sgw-service sgw_srv-name 
        pgw-fteid-in-relocation-cs-rsp  
        no pgw-fteid-in-relocation-cs-rsp  
        end 
Notes: 
 
pgw-fteid-in-relocation-cs-rsp
 enables the sending of the P-GW FTEID in Create Session Response 
procedures where there is an S-GW relocation change. 
 
no pgw-fteid-in-relocation-cs-rsp 
disables the sending of the P-GW FTEID in Create Session 
Response procedures where there is an S-GW relocation change.  
Performance Indicator Changes 
show sgw-service all