Cisco Cisco Packet Data Interworking Function (PDIF) Notas De La Versión
S-GW Changes in Release 15.0
▀ S-GW Enhancements for March 30, 2014
▄ Cisco ASR 5x00 Release Change Reference
548
This command has been enhanced to indicate if the S-GW is configured to enable or disabled the sending of the P-GW
FTEID in Create Session Response procedures where there is an S-GW change.
FTEID in Create Session Response procedures where there is an S-GW change.
PGW Ctrl FTEID in Relocation Create Session Response: Disabled
PGW Ctrl FTEID in Relocation Create Session Response: Enabled
show configuration
This command has been enhanced to indicate if the S-GW is configured to enable or disabled the sending of the P-GW
FTEID in Create Session Response procedures where there is an S-GW change.
FTEID in Create Session Response procedures where there is an S-GW change.
pgw_fteid_in_relocation_cs_rsp
CSCum97952 - Asrt @ fnc: sessmgr_sgw_gtpp_sess_acct_acct_cb
Applicable Products: S-GW
Feature Changes
Enhancement to Handling of IDFT Messages
Certain scenarios were creating an Assert during messaging for the Indirect Data Forwarding Tunnel feature.
Previous Behavior: The Create indirect Data forwarding tunnel Request message was accepted for a bearer even if the
Bearer was in one of the following states:
Bearer was in one of the following states:
Delete Bearer Pending
Delete Bearer command pending
Delete Session Request
As a result, even if the bearer was being deleted due to any one of the message listed below then the system also
accepted the IDFT message.
accepted the IDFT message.
Delete Bearer message is in process and sent to the MME/SGSN
Delete Session Request message is sent to the PGW
Delete Bearer command is pending for the bearer
New Behavior: If any bearer is getting deleted then the system does not create an Indirect Data Forwarding Tunnel for
the bearer. If all the bearers in the request are getting delete the reject complete request message is sent. If for some of
the bearers the request will be accepted then the system processes the create Indirect Data Forwarding Request message.
the bearer. If all the bearers in the request are getting delete the reject complete request message is sent. If for some of
the bearers the request will be accepted then the system processes the create Indirect Data Forwarding Request message.