Cisco Cisco Aironet 350 Wireless LAN Client Adapter Notas de publicación
2
Release Notes for Cisco Aironet Client Adapter Firmware
OL-1281-01
System Requirements
System Requirements
You must have a Cisco Aironet 340 or 350 series client adapter (PC card, LM card, or PCI client adapter)
to install firmware version 4.25.5.
to install firmware version 4.25.5.
EAP Authentication Requires Matching 802.1x Protocol Drafts
If you use Network-EAP authentication on your wireless network, your client devices and infrastructure
devices (access points and bridges) must use the same 802.1x protocol draft. Client firmware release
4.25.5 is Draft 10 of the 802.1x protocol standard. Therefore, if client devices use this version of
firmware, an access point to which they will associate must be configured to also use Draft 10. The table
below lists firmware versions for Cisco Aironet products and the drafts with which they comply.
devices (access points and bridges) must use the same 802.1x protocol draft. Client firmware release
4.25.5 is Draft 10 of the 802.1x protocol standard. Therefore, if client devices use this version of
firmware, an access point to which they will associate must be configured to also use Draft 10. The table
below lists firmware versions for Cisco Aironet products and the drafts with which they comply.
If your clients and infrastructure devices do not have matching 802.1x protocol drafts, upgrade the
firmware in these devices to versions with the same draft number. However, if your access points or
bridges are using firmware version 11.06, you can use their Authenticator Configuration page to select
the draft of the 802.1x protocol that they should use. To set the draft for your access points or bridges,
follow the instructions in the Release Notes for Cisco Aironet Access Points for firmware version 11.06.
You can access these Release Notes at the following URL:
firmware in these devices to versions with the same draft number. However, if your access points or
bridges are using firmware version 11.06, you can use their Authenticator Configuration page to select
the draft of the 802.1x protocol that they should use. To set the draft for your access points or bridges,
follow the instructions in the Release Notes for Cisco Aironet Access Points for firmware version 11.06.
You can access these Release Notes at the following URL:
http://www.cisco.com/univercd/cc/td/doc/product/wireless/airo_350/accsspts/ap350rn/index.htm
Firmware Version
Draft 7
Draft 8
Draft 10
Client adapters (PCM34x/35x and PCI34x/35x)
4.13
—
x
—
4.16
—
x
—
4.23
—
x
—
4.25 and later
—
—
x
Workgroup bridges (WGB34x/352)
8.58
—
x
—
8.61 and later
—
—
x
Access points (AP34x/35x)
11.05 and earlier
—
x
—
11.06 and later
1
1.
The default draft setting in access point and bridge firmware version 11.06 and later is
Draft 10.
Draft 10.
—
x
x
Bridges (BR352)
11.06 and later
—
x
x