Cisco Cisco WAP200E Wireless-G Exterior Access Point - PoE Manual De Mantenimiento
9
Quick Configuration Overview
Wireless-G Exterior Access Point with Power Over Ethernet
Chapter 5
AP Mode
Use this screen to configure the Access Point operation
mode with WDS (Wireless Distribution System).
mode with WDS (Wireless Distribution System).
Administration
You will use the Administration tabs to manage the Access
Point.
Point.
Management
This screen allows you to customize the
password and Simple Network Management Protocol
(SNMP) settings.
(SNMP) settings.
Log
Configure the Log settings for the Access Point on
this screen.
Factory Default
Use this screen to reset the Access Point
to its factory default settings.
Firmware Upgrade
Upgrade the Access Point’s firmware
on this screen.
Reboot
Use this screen to reboot the Access Point.
Config Management
You can back up the configuration
file for the Access Point, as well as save the backup
configuration file to the Access Point.
configuration file to the Access Point.
Status
You will be able to view status information for your local
network, wireless networks, and network performance.
network, wireless networks, and network performance.
Local Network
This screen displays system information,
including software & hardware version, MAC address, and
IP address on the LAN side of the Access Point.
IP address on the LAN side of the Access Point.
Wireless
This screen displays wireless network settings
including SSID, network mode, and wireless channel.
System Performance
This screen displays the current
traffic statistics of the Access Point’s Wireless and LAN
ports.
ports.