Cisco Cisco WAP200E Wireless-G Exterior Access Point - PoE Manual De Mantenimiento
Chapter 6
Advanced Configuration
10
Wireless-G Exterior Access Point with Power Over Ethernet
Chapter 6:
Advanced Configuration
Advanced Configuration
Open your web browser and enter http://192.168.1.245
into the Address field. Press the Enter key and the Password
screen will appear.
into the Address field. Press the Enter key and the Password
screen will appear.
Address Bar
NOTE:
The default IP address is 192.168.1.245.
If the IP address has been changed using DHCP
or via the console interface, enter the assigned
IP address instead of the default.
or via the console interface, enter the assigned
IP address instead of the default.
The first time you open the web-based utility, enter
admin (the default username) in the User name field and
enter it again in the Password field. Click the OK button.
You can change the Access Point’s password later from the
Administration > Management screen.
admin (the default username) in the User name field and
enter it again in the Password field. Click the OK button.
You can change the Access Point’s password later from the
Administration > Management screen.
Login Screen
Web-Based Utility
The first screen that appears in the web-based utility is the
Setup screen. This allows you to change the Access Point’s
general settings. There are five tabs across the top of
the screen: Setup, Wireless, AP Mode, Administration,
and Status. Each tab contains screens that will help you
configure and manage the Access Point.
Setup screen. This allows you to change the Access Point’s
general settings. There are five tabs across the top of
the screen: Setup, Wireless, AP Mode, Administration,
and Status. Each tab contains screens that will help you
configure and manage the Access Point.
Setup > Basic Setup
Setup > Basic Setup
Enter names for the Access Point. The host name can be
used to access the Web Utility through the network if DNS
has been set up. The device name is for the benefit of
identifying your Access Point after you log in.
used to access the Web Utility through the network if DNS
has been set up. The device name is for the benefit of
identifying your Access Point after you log in.
Setup
Host Name
This is the host name assigned to the Access
Point. This host name will be published to your DNS server
if the Access Point is configured to acquire the IP address
through DHCP. In that case, Linksys recommends to follow
the company policy on the host name assignment. The
default name is Linksys.
if the Access Point is configured to acquire the IP address
through DHCP. In that case, Linksys recommends to follow
the company policy on the host name assignment. The
default name is Linksys.
Device Name
You may assign any device name to
the Access Point. This name is only used by the Access
Point administrator for identification purposes. Unique,
memorable names are helpful, especially if you are
employing multiple access points on the same network.
The default name is WAP200E.
Point administrator for identification purposes. Unique,
memorable names are helpful, especially if you are
employing multiple access points on the same network.
The default name is WAP200E.
Network Setup
The selections under this heading allow you to configure
the Access Point’s IP address setting(s).
the Access Point’s IP address setting(s).
IP Settings
Static IP Address
Selected by default, this option is used
to assign a static or fixed IP address to the Access Point.
Local IP Address
•
The IP address must be unique to your
network. The default IP address is 192.168.1.245.
Subnet Mask
•
The Subnet Mask must be the same as
that set on the LAN that your Access Point is connected
to. The default is 255.255.255.0.
to. The default is 255.255.255.0.
Default Gateway
•
Enter the Default Gateway Address,
typically this is the IP address of your router.