Cisco Cisco WAP371 Wireless-AC N Access Point with Single Point Setup Guía De Instalación

The front panel of the device consists of three lights: Power, WLAN, and 
LAN. For full descriptions of the colors of the lights and their indications, 
see 

.

A Kensington lock slot is found under the lights.

The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet 
port to power your device using PoE. It is an auto-sensing, Gigabit 
Ethernet (802.3) port used to connect your WAP devices to network 
devices, such as computers, routers, or switches. We strongly 
recommend that you use a Category 5e or better cable for gigabit 
connectivity.

The 12V DC jack is used to connect the supplied power adapter to the 
Cisco WAP371 if you are not using PoE.

The back panel of the device has a Reset button. See 

 

for information on the Reset button.

If you are using a Cisco RV Series router, the default range for the DHCP 
assigned address is from 192.168.1.100 to 192.168.1.254. Any device 
connecting to the same LAN will be assigned an IP address in this range.

Username

cisco

Password

cisco

LAN IP Address

DHCP address assigned 
by server

Fallback LAN IP

192.168.1.245

Subnetwork Mask

255.255.255.0