Cisco Cisco WAP371 Wireless-AC N Access Point with Single Point Setup 설치 가이드
Cisco WAP371 Wireless Access Point
2
Cisco WAP371 Wireless-AC/N Dual Radio
Access Point with Single Point Setup
Features
Access Point with Single Point Setup
Features
Front Panel
The front panel of the device consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
LAN. For full descriptions of the colors of the lights and their indications,
see
.
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet
port to power your device using PoE. It is an auto-sensing, Gigabit
Ethernet (802.3) port used to connect your WAP devices to network
devices, such as computers, routers, or switches. We strongly
recommend that you use a Category 5e or better cable for gigabit
connectivity.
port to power your device using PoE. It is an auto-sensing, Gigabit
Ethernet (802.3) port used to connect your WAP devices to network
devices, such as computers, routers, or switches. We strongly
recommend that you use a Category 5e or better cable for gigabit
connectivity.
The 12V DC jack is used to connect the supplied power adapter to the
Cisco WAP371 if you are not using PoE.
Cisco WAP371 if you are not using PoE.
for information on the Reset button.
Default SettingHAF1H39Cs
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Parameter
Default Value
Username
cisco
Password
cisco
LAN IP Address
DHCP address assigned
by server
by server
Fallback LAN IP
192.168.1.245
Subnetwork Mask
255.255.255.0
2