Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Guía De Instalación

Slide the Cisco WAP351 into the bracket, placing the cable 
through the break-out tab found in the back of the bracket. Mount 
the Cisco WAP351 with the back panel facing up or facing down. 

The default configuration of the Cisco WAP351 has the Wi-Fi radio turned 
off.

You must perform the initial configuration using a wired Ethernet 

connection. 

To connect the Cisco WAP351 to the wired network:

Connect the Ethernet cable to the Ethernet port of a switch, a router, 
or a PC. 

Connect the other end of the network Ethernet cable to the 
Ethernet port of the Cisco WAP351. 

The power adapter is sold separately for the Cisco WAP351. If PoE 
is not provided, connect the power adapter (48V/1.25 A) to the 48V 
DC jack. For more information about the power adapter, see 

.

After installation, all lights should be active. Refer to 

 for details about the different lights on the Cisco 

WAP351.