Cisco Cisco WAP131 Wireless-N Dual Radio Access Point with PoE Guía De Instalación

POWER—The POWER button is used to turn the power on and off. It is not 
applicable when using PoE.

12V DC—The 12V DC jack is used to connect the supplied power adapter 
to the Cisco WAP131 if you are not using PoE.

Kensington Lock Slot—The Kensington lock slot is used to attach a cable 
and lock to the Cisco WAP131. 

If you are using a Cisco RV Series router, the default range for the DHCP 
assigned address is from 192.168.1.100 to 192.168.1.254. Any device 
connecting to the same LAN will be assigned an IP address in this range.

You can place the Cisco WAP131 horizontally on a surface so that it sits on 
its four rubber feet, or place it vertically on a desktop by using the stand on 
its left side. 

To place the Cisco WAP131 vertically on a desktop, follow these steps: 

Locate the left side panel of the Cisco WAP131, and rotate the stand 
90 degrees clockwise or anticlockwise.

Place the stand upward so that the Cisco WAP131 stands on a flat 
desktop.

Username

Password

LAN IP Address

DHCP address assigned by server

Fallback LAN IP

Subnetwork Mask

255.255.255.0