Cisco Cisco Aironet 1200 Access Point Notas de publicación

If your access point does not run Cisco IOS software, you can use the conversion tool and the upgrade 
image or the upgrade image alone to convert the access point system to Cisco IOS operation. 

Use the upgrade image with the conversion tool to maintain the current access point configuration after 
the conversion. Refer to the Cisco Aironet Conversion Tool for Cisco IOS Software for complete 
instructions on using the upgrade image with the conversion tool. Click this link to browse to the Cisco 
Aironet Conversion Tool for Cisco IOS Software:

To convert to Cisco IOS software without maintaining the current access point configuration, load the 
upgrade image on the access point just as you would when performing a firmware upgrade. 

Follow these steps to convert your access point system to Cisco IOS software and reset the configuration 
to factory defaults:

Type the access point’s IP address in your browser’s address line to browse to the access point 
web-browser interface.

Click Setup on the Summary Setup screen.

Under Services, click Cisco Services.

Under Fully Update Firmware, click Through Browser.

Click Browse to browse to the upgrade image file and select it.

Click Browser Update Now. The upgrade process begins. 

When the upgrade completes, a message appears that asks you to wait for the access point to reboot.

Do not power-cycle the access point until it has completely rebooted. After the upgrade process, the 
reboot can take up to 30 minutes to complete. Removing power from the access point during the reboot 
can make the unit inoperable.

After it reboots, the access point runs Cisco IOS Release 12.2(13)JA2. To access your access point, 
browse to the access point and enter Cisco as the administrator username and Cisco as the password.