Cisco Cisco Aironet 1200 Access Point Notas de publicación

This section describes important information about access points running Cisco IOS software. For more 
information on Cisco IOS releases for access points, refer to the release notes for specific releases. Click 
this link to browse to the release notes for Cisco IOS Release 12.2(13)JA2:

When a Cisco Aironet client device associates to a 1200 series access point running Cisco IOS software, 
the access point MAC address that appears on the Status page in the Aironet Client Utility (ACU) is the 
MAC address for the access point radio. The MAC address for the access point Ethernet port is printed 
on the label on the back of the access point.

When a client device roams from an access point (such as access point alpha) to another access point 
(access point bravo), a message appears in the event log on access point alpha stating that the client 
roamed to access point bravo. The MAC address that appears in the event message is the MAC address 
for the radio in access point bravo instead of the Ethernet port in access point bravo.

Access points that do not run Cisco IOS software (340 series access points and 350 series access points 
that have not been upgraded to Cisco IOS software) cannot serve as parents for repeater access points 
that run Cisco IOS software.

For the most up-to-date, detailed troubleshooting information, refer to the Cisco Technical Support 
Website at

.

These documents describe installation and configuration of 1200 series access points: