Cisco Cisco Aironet 1600i Access Point

IPv6 access lists (ACL) are used to filter traffic and restrict access to the router. IPv6 prefix lists are used 
to filter routing protocol updates. 

Beginning in privileged EXEC mode, use these commands to to configure the access list globally and 
assign it to interface:

ap(config)# ipv6 access-list acl-name

Beginning in privileged EXEC mode, you can use the command given in 

 for IPv6 Access List 

configuration.

Beginning in privileged EXEC mode, use these commands to assign the globally configured ACL to the 
outbound and inbound traffic on layer3 interface:

ap(config)# interface interface

ap(config)# ipv6 traffic-filter acl-name in/out

RADIUS iserver is a background process serving three functions:

authenticate users before granting them access to the network

authorize users for certain network services

account for the usage of certain networkservices

See XXX - cross reference to the RADIUS Configuration section

The WDS and the infrastructure access points communicate over a multicast protocol called WLAN 
Context Control Protocol (WLCCP).

Cisco IOS Release 15.2(4)JA supports communication between the WDS and Access Point through IPv6 
addresses. The WDS works on a Dual Stack; that is, it accepts both IPv4 and IPv6 registeration. 

Set a command to its defaults.

Specify packets to reject.

Evaluate an access list.

Exit from access-list configuration mode.

Negate a command or set its defaults.

Specify packets to forward.

Set an access list entry comment.

Set a sequence number for this entry.