Cisco Cisco Aironet 1040 Series Access Point
C H A P T E R
4-1
Cisco IOS Software Configuration Guide for Cisco Aironet Access Points
OL-30644-01
4
Configuring the Access Point for the First Time
This chapter describes how to configure basic settings on the wireless device for the first time. The
contents of this chapter are similar to the instructions in the quick start guide that shipped with the
wireless device. You can configure all the settings described in this chapter using the CLI, but it might
be simplest to browse to the wireless device web-browser interface to complete the initial configuration
and then use the CLI to enter additional settings for a more detailed configuration.
contents of this chapter are similar to the instructions in the quick start guide that shipped with the
wireless device. You can configure all the settings described in this chapter using the CLI, but it might
be simplest to browse to the wireless device web-browser interface to complete the initial configuration
and then use the CLI to enter additional settings for a more detailed configuration.
This chapter contains the following sections:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Note
In this release, the access point radio interfaces are disabled by default.
Before You Start
Before you install the wireless device, make sure you are using a computer connected to the same
network as the wireless device, and obtain the following information from your network administrator:
network as the wireless device, and obtain the following information from your network administrator: