Cisco Cisco Aironet 3500e Access Point

4-22

Cisco IOS Software Configuration Guide for Cisco Aironet Access Points

OL-30644-01

Chapter 4 Configuring the Access Point for the First Time

Configuring System Power Settings Access Points

ipv6 address autoconfig

ipv6 enable

ip forward-protocol nd

ip http server

no ip http secure-server

ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag

ip radius source-interface BVI1

radius-server attribute 32 include-in-access-req format %h

radius-server vsa send accounting

radius server 10.10.11.100

address ipv4 10.10.11.100 auth-port 1645 acct-port 1646

key 7 01300F175804

Configuring System Power Settings Access Points

The AP 1040, AP 802, AP 1140, AP 1550, AP 1600, AP 2600, AP 3500, AP 3600 and AP 1260 disable
the radio interfaces when the unit senses that the power source to which it is connected does not provide
enough power. Depending on your power source, you might need to enter the power source type in the
access point configuration. Choose the Software > System Configuration page on the web-browser
interface, and then select a power option.

Figure 4-1

shows the System Power Settings section of the

System Configuration page.

Figure 4-1

Power Options on the System Software: System Configuration Page

Using the AC Power Adapter

If you use the AC power adapter to provide power access point, you do not need to adjust the access point
configuration.

Using a Switch Capable of IEEE 802.3af Power Negotiation

If you use a switch to provide Power over Ethernet (PoE) to the 1040, 1130, 1140, 1240, 1250, and 1260
access point, and the switch supports the IEEE 802.3af power negotiation standard, select Power
Negotiation on the System Software: System Configuration page.