Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Guía De Instalación

The front panel of the device consists of a single system LED. For a full 
description of the colors of the light and its indications, see 

The back panel of the device has a water proof RJ-45 Ethernet port and 
reset bottom. Facing the side of the device, the right port (labeled 
"ETH0/PD") is an 802.3at and 802.3af Power over Ethernet (PoE) port 
which is used to power your device. The left port (labeled "ETH1") is a 
general Gigabit Ethernet LAN interface. Both are auto-sensing, Gigabit 
Ethernet (802.3) ports used to connect your WAP devices to network 
devices, such as computers, routers, or switches. We strongly 
recommend that you use a Category 5e or better cable for Gigabit 
connectivity.

The side panel of the device has a Reset button at right. See 

 for 

information on the Reset button.

If you are using a Cisco RV Series router, the default range for the DHCP 
assigned address is from 192.168.1.100 to 192.168.1.254. Any device 
connecting to the same LAN will be assigned an IP address in this range.

If your network does not have an existing DHCP server, the WAP571E will 
start a DHCP server for WLAN stations and stop the DHCP client when 
WAP571E is in factory default. The DHCP server will assign the IP address 
from 192.168.1.20 to 192.168.1.100.

Username

cisco

Password

cisco

LAN IP Address

DHCP address assigned 
by server

Fallback LAN IP

192.168.1.245

Subnetwork Mask

255.255.255.0