Cisco Cisco WAP571E Wireless-AC N Premium Dual Radio Outdoor Access Point Guía De Instalación

You can perform the initial configuration using either a wired or wireless 
connection. The default configuration of the WAP 571 has the Wi-Fi radio 
turned on.

To connect the WAP 571E to the wired network:

Connect the Ethernet cable to the Ethernet port of a PoE switch. 

Connect the other end of the network Ethernet cable to the 
Ethernet port (PoE) of the wireless access point. 

WAP571E bundles the two Ethernet ports to be link aggregation 

mode. If the two Ethernet ports have been connected at the same time, 
the link partner must also support link aggregation.

This wireless default configuration will not allow traffic between WiFi and 
Ethernet; users will need to go through the setup wizard to resume the 
traffic between WiFi and Ethernet.

To connect the WAP 571E to the network wirelessly:

Use wireless clients to locate the WAP571E’s SSID (CiscoSB-
Setup). 

Use the ‘cisco123’ passkey to access the access point.

The system provides a one-time-only access to configure the 

access point using a wireless connection.

After installation, all lights should be active. Refer to 

 for details about the different lights on the WAP 

571E.