Cisco Cisco Aironet 1200 Access Point Guía De Instalación
2
FAQs for the Cisco Aironet Conversion Tool Version 2.1 for Cisco IOS Software
OL-6239-01
Conversion FAQs
Conversion FAQs
This section contains FAQs for the conversion tool.
Q.
Which VxWorks access point versions does the conversion tool support?
A.
lists the supported VxWorks access points and operating system versions:
Q.
What are other conversion tool requirements for converting VxWorks access points?
A.
Conversion tool requirements are given here:
1.
A PC running the Windows 2000 or XP operating system and is not supported if Terminal Services
is installed.
is installed.
2.
Minimum PC hardware:
–
Processor: Pentium III or equivalent
–
Speed: 850 MHz
–
RAM: 128 MB
–
Hard disk free space: 250 MB (4 MB for each helper image upgrade task)
3.
The person installing and running the conversion tool must be logged in and must be the
administrator of the PC.
administrator of the PC.
4.
All the access points (source and target) must have a user enabled with full access privileges (Write,
SNMP, Ident, Firmware, and Admin).
SNMP, Ident, Firmware, and Admin).
–
Use the User Information page to configure user privileges (Setup > Security > User
Information)
Information)
5.
SNMP must be enabled on the source and target access points (Setup > SNMP > Simple Network
Management Protocol (SNMP): Enabled).
Management Protocol (SNMP): Enabled).
6.
The conversion tool uses SNMP commands to obtain configuration data from the source access
point, but some security information cannot be accessed using SNMP. Before you use the conversion
tool, you should obtain the following source access point security information:
point, but some security information cannot be accessed using SNMP. Before you use the conversion
tool, you should obtain the following source access point security information:
–
The WEP keys used for the radio interfaces and VLANs
–
The LEAP passwords for repeater access points
–
The passwords used with the User Manager Configuration
–
AAA Server Configuration Secret Keys
Table 1
Supported Access Points, VxWorks Versions, and Images
Access Points
VxWorks Versions
Helper Image Filename
Cisco IOS Version
(after conversion)
(after conversion)
AP1200
AP1220
AP1220
12.03T, 12.02T1,
12.01T1, 12.00T,
11.56, or 11.54T
12.01T1, 12.00T,
11.56, or 11.54T
AP1200-Cisco-IOS-Upgrade-Image-v3.img
12.2(11)JA3
AP350
12.03T, 12.02T1,
12.01T1, 12.00T,
11.23T, or 11.21
12.01T1, 12.00T,
11.23T, or 11.21
AP350-Cisco-IOS-Upgrade-Image-v2.img
12.2(13)JA1