Cisco Cisco Aironet 1200 Access Point Notas de publicación
4
Release Notes for Cisco Aironet 1100, 1130, 1200, 1230, 1240, and 1300 Series Access Points for Cisco IOS Release 12.3(11)JX1
OL-10752-02
New Features
Step 8
Wait until the access point reboots as indicated by all LEDs turning green followed by the Status LED
blinking green.
blinking green.
Step 9
After the access point reboots, reconfigure the access point using the GUI or the CLI.
New Features
This section lists new features in Cisco IOS Release 12.3(11)JX.
lists the features that are
supported on the devices that support this release.
Lightweight Upgrade and Recovery Support
This feature allows a Cisco autonomous access point to communicate with a Cisco Wireless LAN
Controller in order to receive a full LWAPP image. Access points shipping with LWAPP or selected
autonomous access points upgraded from autonomous to lightweight mode use the LWAPP Upgrade and
Recovery Support feature to receive their full LWAPP image from the controller. The LWAPP Upgrade
and Recovery Support feature is also used as a recovery image if the full LWAPP image becomes
corrupted. Access points using this feature have limited functionality and their radios are disabled until
the Cisco Wireless LAN Controller sends them the full LWAPP image.
Controller in order to receive a full LWAPP image. Access points shipping with LWAPP or selected
autonomous access points upgraded from autonomous to lightweight mode use the LWAPP Upgrade and
Recovery Support feature to receive their full LWAPP image from the controller. The LWAPP Upgrade
and Recovery Support feature is also used as a recovery image if the full LWAPP image becomes
corrupted. Access points using this feature have limited functionality and their radios are disabled until
the Cisco Wireless LAN Controller sends them the full LWAPP image.
Pre-stage Configuration for LWAPP Access Points
This feature simplifies the deployment of LWAPP access points in remote locations by adding a new set
of CLI’s to the Recovery IOS image. The static IP address, Netmask, Default gateway, and Primary
Controller IP address may now be configured on the access point. Configuring the Primary Controller
IP address will help the access point discover and register a specific Controller over the WAN links. In
a deployment scenario where a DHCP server is not available in remote locations the CLIs may be used
to configure the static IP address and the initial LWAPP controller information.
of CLI’s to the Recovery IOS image. The static IP address, Netmask, Default gateway, and Primary
Controller IP address may now be configured on the access point. Configuring the Primary Controller
IP address will help the access point discover and register a specific Controller over the WAN links. In
a deployment scenario where a DHCP server is not available in remote locations the CLIs may be used
to configure the static IP address and the initial LWAPP controller information.
The new pre-stage CLI commands are listed and described in Upgrading Autonomous Cisco Aironet
Access Points to Lightweight Mode. Click this link to browse to that document:
Access Points to Lightweight Mode. Click this link to browse to that document:
Table 1
New Features Introduced for Access Points in Cisco IOS Release 12.3(11)JX
Feature
1100 Series 1130 Series 1200 Series 1230 Series 1240 Series 1300 Series
Lightweight Upgrade
and Recovery Support
and Recovery Support
1
1.
This release provides, for the first time, lightweight upgrade and recovery support for 1100 and 1300 series access points.
Lightweight support for the other access points listed in this table is provided by both this release and by Cisco IOS Release
12.3(7)JX.
Lightweight support for the other access points listed in this table is provided by both this release and by Cisco IOS Release
12.3(7)JX.
x
x
x
x
x
x
Pre-stage
Configuration for
LWAPP Access Points
Configuration for
LWAPP Access Points
x
x
x
x
x
x