Cisco Cisco Prime IP Express Jumpstart 8.2 Guía De Instalación

Configuring Cisco Prime IP Express Jumpstart requires you to do the following configuration steps to 
connect it to the network:

To configure the Cisco Prime IP Express Jumpstart:

Configure the UCS CIMC Network Connection. To configure this, follow the steps in the Connecting 
and Powering On the Server (Standalone Mode) chapter of the enclosed Cisco UCS C220 Server 
Installation and Service Guide or you can see the document available online at 

You have to configure NIC Redundancy as None in the Connecting and Powering On (Standalone Mode) 
procedure.

The CIMC gives you insight into the hardware as well as support for a virtual KVM console allowing 
remote management of the ESXi layer. For details on CIMC, see the Cisco UCS C-Series Servers 
Integrated Management Controller GUI Configuration Guide available at 

After configuring the network information for the UCS CIMC console, use the virtual KVM console that 
the CIMC console provides to configure the network information for the ESXi hypervisor.

Use a browser to connect to the IP address of the CIMC console.

Log into the CIMC console.

The default username is admin and default password is password, but you should change the password 
at your earliest convenience.

On the Server Summary page, in the Actions pane, click Launch KVM Console. You will be asked to 
approve the running of the application, as this operation downloads code to run on your system. After 
some delay, the KVM Console window is displayed.

If login fails, it may be either that someone else already has a virtual KVM console already active for 
this UCS C220 server or that your browser is not configured to run Java Web Start.