Cisco Cisco Prime Access Registrar Jumpstart 7.0 Guía De Instalación
4
3
Configuring Prime Access Registrar Jumpstart
Configuring Prime Access Registrar Jumpstart requires you to do the following configuration steps to connect it to the network:
•
•
•
Configuring Prime Access Registrar Jumpstart
To configure the Prime Access Registrar Jumpstart:
Step 1
Configure the UCS CIMC Network Connection. To configure this, follow the steps in the Connecting and Powering
On The Server (Standalone Mode) chapter of the enclosed Cisco UCS C220 Server Installation and Service Guide or
you can see the document available online at
On The Server (Standalone Mode) chapter of the enclosed Cisco UCS C220 Server Installation and Service Guide or
you can see the document available online at
You have to configure NIC Redundancy as None in the Connecting and Powering On The Server (Standalone Mode) procedure.
The CIMC gives you considerable insight into the hardware as well as support for a virtual KVM console allowing remote
management of the ESXi layer. For details on CIMC, see the Cisco UCS C-Series Servers Integrated Management Controller
GUI Configuration Guide available at
management of the ESXi layer. For details on CIMC, see the Cisco UCS C-Series Servers Integrated Management Controller
GUI Configuration Guide available at
Configuring Network Information for ESXi
After configuring the network information for the UCS CIMC console, use the virtual KVM console that the CIMC console
provides to configure the network information for the ESXi hypervisor.
provides to configure the network information for the ESXi hypervisor.
Note
Note down the VMware ESXi license key. You will need the license key to reinstall VMWare ESXi in case of a failure.
To configure the Network Information for ESXi:
Step 1
Use a browser to connect to the IP address of the CIMC console.
Step 2
Log into the CIMC console using the login credentials.
Note
The default username is admin and default password is password. While configuring the CIMC console, you should
change the password.
change the password.
Step 3
On the Server Summary window, in the Actions pane, click Launch KVM Console. You will be asked to approve the
running of the application, as this operation downloads code to run on your system. After some delay, the KVM
Console window is displayed.
running of the application, as this operation downloads code to run on your system. After some delay, the KVM
Console window is displayed.
Note
If login fails, it may be that someone else already has a virtual KVM console already active for this UCS C220 server
or that your browser is not configured to run Java Web Start. In that case, log that user off and try again.
or that your browser is not configured to run Java Web Start. In that case, log that user off and try again.
The initial screen on the KVM console displays VMware ESXi 5.1.0.