Cisco Cisco ONS 15454 M12 Multiservice Transport Platform (MSTP) Guía De Instalación
10
Installing the 32WSS-L Card in the Cisco ONS 15454 SONET/SDH
78-17342-01
Install the 32WSS-L Card
Figure 4
Installing a Card in the Cisco ONS 15454 (ANSI)
Step 1
Display the card installation plan for the node using one of the following sources:
•
The Cisco MetroPlanner Site Dialog window for the node you are provisioning.
•
CTC node view with slots preprovisioned based on the Cisco MetroPlanner Site Dialog window.
•
Written slot plan. The plan must be based on the Cisco MetroPlanner Site Dialog window for your
installation.
installation.
Step 2
Remove the 32WSS-L card from its packaging, then remove the protective caps from the card’s rear
connectors.
connectors.
Step 3
Open the card latches/ejectors.
Step 4
Use the latches/ejectors to firmly slide the card along the slot guide rails until the card plugs into the
receptacle at the back of the slot.
receptacle at the back of the slot.
Step 5
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Note
It is possible to close the latches/ejectors when the card is not completely plugged into the
backplane. Ensure that you cannot insert the card any further.
backplane. Ensure that you cannot insert the card any further.
Step 6
Verify the LED activity:
•
The FAIL LED turns on for approximately 35 seconds.
•
The FAIL LED blinks for approximately 40 seconds.
•
All LEDs turn on and then turn off within 5 seconds.
FAN F
AIL
CRIT
MAJ
MIN
39391
Guide rail
Ejector