Cisco Cisco ONS 15454 M12 Multiservice Transport Platform (MSTP) Guía De Instalación

 describes the port-level LEDs on the MXP_MR_10DME_C and MXP_MR_10DME_L cards. 

The MXP_MR_10DME_C card has the following specifications:

Payload configuration

FC1G—Fibre Channel 1.06 Gbps

FC2G—Fibre Channel 2.125 Gbps

FC4G—Fibre Channel 4.25 Gbps

FICON1G—Fiber CON 1.06 Gbps (IBM signal)

FICON2G—Fiber CON 2.125 Gbps (IBM signal)

FICON4G—Fiber CON 4.25 Gbps (IBM signal)

ONE_GE—One Gigabit Ethernet 1.125 Gbps

Mixed configurations up to maximum line rate of 10.0 Gbps. See the Cisco ONS 15454 DWDM 
Reference Manual for more information on mixed-mode operation.

Client ports: 8x SFP

Line (trunk side) 

Bit rate: 2.488 Gbps for OC-48/STM-16, 9.952 Gbps for OC-192/STM-64

Code: Scrambled NRZ 

Fiber: 1310-nm single-mode or 850-nm multimode

Loopback modes: Terminal and facility

Port LED
(eight LEDs, four for 
each group, one for each 
SFP)

Green/Red/Amber/Off

When green, the port LED indicates that the client port is either in service 
and receiving a recognized signal (that is, no signal fail), or Out of Service 
and Maintenance (OOS,MT or locked, maintenance) and the signal fail and 
alarms are being ignored.

When red, the port LED indicates that the client port is in service but is 
receiving a signal fail (LOS).

When amber, the port LED indicates that the port is provisioned and in a 
standby state.

When off, the port LED indicates that the SFP is either not provisioned, out 
of service, not properly inserted, or the SFP hardware has failed.

Green DWDM LED

The green DWDM LED indicates that the DWDM port is in service and that 
it is receiving a recognized signal.