Cisco Cisco ONS 15454 M6 Multiservice Transport Platform (MSTP)
NTP-G81 Change CTC Network Access
This procedure changes or deletes network information,
including IP settings, static routes, OSPF options, proxy
tunnels, and firewall tunnels.
including IP settings, static routes, OSPF options, proxy
tunnels, and firewall tunnels.
Purpose
None
Tools/Equipment
• "DLP-G46 Log into CTC" task in the "
" document.
• Complete the "NTP-G26 Set Up CTC Network Access"
procedure in the chapter, "Turn Up a Node" of the Cisco
ONS 15454 DWDM Configuration Guide.
ONS 15454 DWDM Configuration Guide.
• Complete the "NTP-G103 Back Up the Database"
procedure in the chapter, "Maintain the Node" of the
Cisco ONS 15454 DWDM Configuration Guide.
Cisco ONS 15454 DWDM Configuration Guide.
Prerequisite Procedures
As needed
Required/As Needed
Onsite or remote
Onsite/Remote
Provisioning or higher
Security Level
Additional ONS 15454 networking information, including IP addressing examples, dual IP addressing
(secure mode) information, static route scenarios, OSPF protocol information, and Routing Information
Protocol (RIP) options are provided in the "Management Network Connectivity" chapter of the Cisco
ONS 15454 DWDM Configuration Guide.
(secure mode) information, static route scenarios, OSPF protocol information, and Routing Information
Protocol (RIP) options are provided in the "Management Network Connectivity" chapter of the Cisco
ONS 15454 DWDM Configuration Guide.
Note
Procedure
Step 1
Perform any of the following tasks as needed:
•
DLP-G162 Change IP Settings, on page 35
•
DLP-G265 Lock Node Security, on page 37
•
•
DLP-G267 Disable Secure Mode, on page 39
•
DLP-G163 Modify a Static Route, on page 41
•
DLP-G164 Delete a Static Route, on page 42
•
DLP-G165 Disable OSPF, on page 43
34