Cisco Cisco Prime LAN Management Solution 4.2 Notas de publicación
6
Release Notes for Cisco Prime LAN Management Solution 4.2.2
OL-25950-02
Installing Cisco Prime LAN Management Solution 4.2.2
System Drive:\psu_download—On Windows
Software Center does not support downloading software or device updates into the same directory where
you have installed Cisco Prime LAN Management Solution, or any of its sub- directories. Also, you
cannot download software or device updates under System directories.
you have installed Cisco Prime LAN Management Solution, or any of its sub- directories. Also, you
cannot download software or device updates under System directories.
Step 5
Enter the location, or browse to the location using the Browse tab.
The destination location must have casuser write-permissions.
Step 6
Click Next.
The Summary page appears with a summary of your inputs.
Step 7
Click Finish to confirm the download operation.
Installing Cisco Prime LAN Management Solution 4.2.2
This section describes on how you can install Cisco Prime LMS 4.2.2 on Solaris, Soft Appliance, and
Windows systems.
Windows systems.
The LMS 4.2.2 installation program takes approximately 50 minutes to complete on Windows, Soft
Appliance and Solaris, on a single server with the recommended hardware requirements.
Appliance and Solaris, on a single server with the recommended hardware requirements.
This can take more than two hours if you perform network management integration while installing.
•
If Virus Check is enabled in your system, then installation of LMS 4.2.2 will take a longer time.
•
If HP Openview or Netview is running on your system, installation will take a longer time. Stop
these services to run a faster installation.
these services to run a faster installation.
This sections contains:
•
•
•
•
•
•
Prerequisites for Installing Cisco Prime LMS 4.2.2 Software
Before you install Cisco Prime LMS 4.2.2, LMS 4.2 or LMS 4.2.1 must be installed on your system. For
more details, refer
more details, refer
in Installing and Migrating to Cisco Prime LAN Management Solution
4.2.
Installing LMS 4.2.2 on Solaris
To install the LMS 4.2.2 on a Solaris system for the first time:
Step 1
Navigate to the location on your system, where you have downloaded the lms4_2_2_sol_k9.zip.