Cisco PowerKEY CableCARD Module 800 Guía Del Usuario
Chapter 1 Set Up the PowerKEY CableCARD or M-Card Module
16
4014667 Rev C
Notes on MMI Options
The MMI Options section of the Set CableCARD MMI Copy Protection screen
The MMI Options section of the Set CableCARD MMI Copy Protection screen
requires special attention. The following table illustrates the results of the selections
you make in the MMI Options section.
Display MMI for
bi-directional
device
Bidirectional timeout
(decimal setting)
Autobinding
Enabled?
MMI screen
displays on
TV?
Checked
Set to zero (0)
No
Yes
Not checked
N/A
Yes
No
Checked
Set to a number that is
> zero (0)
Note: Cisco recommends
Note: Cisco recommends
that this number be set to
180 seconds.
Yes (Attempts to
autobind for the
length of the
Bidirectional
timeout setting)
Yes (After the
Bidirectional
timeout period
expires if CP
authorization
has not been
received by the
CableCARD or
M-Card
module)
Note: To disable autobinding, go to
Disabling Autobinding (on page 16).
Disabling Autobinding
1 Open the Configure CableCARD Server screen.
2 In the appropriate fields within the Configure CableCARD Server screen,
2 In the appropriate fields within the Configure CableCARD Server screen,
complete the following steps.
a Change the CableCARD Server IP Address to all zeros (0.0.0.0).
b Change the CableCARD Server Port Number to zero (0).
c Click Save CableCARD Server Configuration on the left side of the screen to
a Change the CableCARD Server IP Address to all zeros (0.0.0.0).
b Change the CableCARD Server Port Number to zero (0).
c Click Save CableCARD Server Configuration on the left side of the screen to
save these parameters.
3 Open the Set CableCARD MMI Screen Copy Protection Screen and complete the
following steps.
a Check the Display MMI for bi-directional device box in the upper left
a Check the Display MMI for bi-directional device box in the upper left
section of the Set CableCARD MMI Copy Protection screen.
b Enter a zero (0) in the Bidirectional timeout (decimal seconds) box.
4 Click Save.
5 Stop and then restart (bounce) the CCardServer process on the DNCS.
5 Stop and then restart (bounce) the CCardServer process on the DNCS.