Cisco Multi-Stream CableCARD Module Guía De Instalación
Chapter 7 Upgrade PCG Software
68
78-4017672-01 Rev E
Upgrading the Software
Installing the PCG Operating System (Platform) from CD
Complete the following steps to install the PCG Operating System (OS) Platform.
1 Press the DVD/CD eject button to open the drive.
2 Place the PCG OS Platform Installation CD into the drive tray and close the tray.
1 Press the DVD/CD eject button to open the drive.
2 Place the PCG OS Platform Installation CD into the drive tray and close the tray.
The server will boot from the CD. You will see a boot welcome screen and the
prompt boot:
prompt boot:
3 Type platform and press Enter. The installation will continue unattended and
takes about ten minutes to complete. After installation, the server will eject the
CD and reboot. You will be returned to the prompt pcg login:
Important: You may be presented with a warning screen that displays the
following message:
CD and reboot. You will be returned to the prompt pcg login:
Important: You may be presented with a warning screen that displays the
following message:
The partition table on device sda was unreadable ...
Would you like to initialize this drive, erasing ALL DATA?
Answer yes to
this prompt and proceed.
4 Did the pcg login: prompt appear, indicating that the installation was successful?
If yes, proceed with the next section, Upgrading the PCG Bootup Application
(on page 68).
(on page 68).
If no, continue with step 5.
5 Did GRUB display on the screen for more than 10 minutes?
If yes, the installation may have failed while building the GRUB bootloader.
Go to Recover from a PCG Platform Installation Failure (on page 83) in the
appendix.
Go to Recover from a PCG Platform Installation Failure (on page 83) in the
appendix.
If no, contact Cisco Services.
Upgrading the PCG Bootup Application
1 Log on to the PCG and press the CD eject button to open the drive. Place the
PCG Bootup Installation CD into the drive tray of the PCG and close the tray.
2 Open the /opt/pcg/mon_app/mon.cfg file with a text editor.
3 Change the skip-bootp value to no.
3 Change the skip-bootp value to no.
Example:
skip-bootp = no
4 Save and close the file.