Cisco PowerKEY CableCARD Module 800 Guía De Instalación
Appendix E
Manually Configure the PCG
100
78-4017672-01 Rev E
GATEWAY1=172.18.0.254
NETMASK1=255.255.255.255
ADDRESS1=10.250.0.1
NETMASK1=255.255.255.255
ADDRESS1=10.250.0.1
Configure the /etc/sysconfig/network-scripts/route-eth1 File
1 From the PCG, open the /etc/sysconfig/network-scripts/route-eth1 file in an
editor.
2 Add the following lines:
GATEWAY0=[SCS Interface Default Gateway]
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
Example: If the value of SCS Interface Default Gateway used in the DNCS/ISDS
the GUI (above) is 172.140.10.254, you will add the following lines:
GATEWAY0=172.140.10.254
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
Note: If this interface needs to access additional networks, such as a subnet to
which the PCG is not directly connected, configure additional routes within the
appropriate route-eth0 or route-eth1 file.
Important: ALL routes must be included in the route-eth0 and route-eth1 files. A
sample of how to add additional entries is shown below.
GATEWAY0=172.18.0.254
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
GATEWAY1=172.18.0.254
NETMASK1=255.255.255.255
ADDRESS1=10.250.0.1
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
Example: If the value of SCS Interface Default Gateway used in the DNCS/ISDS
the GUI (above) is 172.140.10.254, you will add the following lines:
GATEWAY0=172.140.10.254
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
Note: If this interface needs to access additional networks, such as a subnet to
which the PCG is not directly connected, configure additional routes within the
appropriate route-eth0 or route-eth1 file.
Important: ALL routes must be included in the route-eth0 and route-eth1 files. A
sample of how to add additional entries is shown below.
GATEWAY0=172.18.0.254
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
GATEWAY1=172.18.0.254
NETMASK1=255.255.255.255
ADDRESS1=10.250.0.1