Cisco PowerKEY CableCARD Module 800 Guía Del Usuario
Chapter 1 Set Up the PowerKEY CableCARD or M-Card Module
4
78-4011765-01 Rev C
Configure the DNCS for CableCARD and M-Card
Support
Introduction
In order for the PowerKEY CableCARD or M-Card modules to function properly,
you must initially configure the DNCS. The following steps summarize the process.
Detailed steps appear later in this section.
Process Overview
If you have not set up your DNCS to configure CableCARD or M-Card modules,
you need to complete the following stages. Otherwise, go to Before You Begin
(on page 4).
Important! Stages 3 and 4 only apply to SR 4.0 SP1 and earlier.
1 Load the EMM CD (or download the EMMs from the Cisco FTP site) and
Important! Stages 3 and 4 only apply to SR 4.0 SP1 and earlier.
1 Load the EMM CD (or download the EMMs from the Cisco FTP site) and
confirm that the correct CableCARD or M-Card module types exist.
Note: Refer to the Explorer® Digital Home Communications Terminal Staging Guide
Note: Refer to the Explorer® Digital Home Communications Terminal Staging Guide
for more information.
2 Set up the DNCS for OpenCable compliance.
3 Create an mmi.txt and a gfc.txt file on the DNCS.
4 Make the mmi.txt and gfc.txt files available on the BFS Data Carousel.
5 Configure the CableCARD server on the DNCS.
6 Configure EAS to properly function with the CableCARD and M-Card modules.
7 Verify the setup of the CableCARD and M-Card modules on the DNCS.
3 Create an mmi.txt and a gfc.txt file on the DNCS.
4 Make the mmi.txt and gfc.txt files available on the BFS Data Carousel.
5 Configure the CableCARD server on the DNCS.
6 Configure EAS to properly function with the CableCARD and M-Card modules.
7 Verify the setup of the CableCARD and M-Card modules on the DNCS.
Before You Begin
You need to obtain the EMM keys for the PowerKEY CableCARD and/or M-Card
modules that you intend to provision on the DNCS at this time. If your EMM CDs or
files have been lost or misplaced, contact Cisco Services.