Cisco Multi-Stream CableCARD Module Guía De Instalación
Install the PKES Platform
4034718 Rev B
13
Configuring the Management Network Interfaces
Follow these instructions to configure the management network interface for the
PKES. This is the interface that is used to communicate with the ISDS and other
management devices within the network.
1 On the PKES, type cd /etc/sysconfig/network-scripts and then press Enter. The
PKES. This is the interface that is used to communicate with the ISDS and other
management devices within the network.
1 On the PKES, type cd /etc/sysconfig/network-scripts and then press Enter. The
/etc/sysconfig/network-scripts becomes the working directory.
2 Type vi ifcfg-eth0 and then press Enter. The ifcfg-eth0 file opens for editing
using the vi text editor.
3 Add the following information to the ifcfg-eth0 file:
DEVICE=eth0
BOOTPROTO=static
DHCPCLASS=
HWADDR=00:0E:0C:E5:F1:20
IPADDR=172.105.1.173
NETMASK=255.255.255.240
ONBOOT=yes
Important: The values used for IPADDR and NETMASK in the preceding
example are for illustration, only. Use the actual IP address and netmask of the
PKES in use on your system.
BOOTPROTO=static
DHCPCLASS=
HWADDR=00:0E:0C:E5:F1:20
IPADDR=172.105.1.173
NETMASK=255.255.255.240
ONBOOT=yes
Important: The values used for IPADDR and NETMASK in the preceding
example are for illustration, only. Use the actual IP address and netmask of the
PKES in use on your system.
4 Save the file and close the vi editor.
Configuring the Asset Ingest Network Interface
Follow these instructions to configure the Asset Ingest network interface for the
PKES. The Asset Ingest network interface is the interface that is used to
communicate with video-on-demand (VOD) equipment, such as the AMS and NAS
devices within the network.
1 On the PKES, type cd /etc/sysconfig/network-scripts and then press Enter. The
PKES. The Asset Ingest network interface is the interface that is used to
communicate with video-on-demand (VOD) equipment, such as the AMS and NAS
devices within the network.
1 On the PKES, type cd /etc/sysconfig/network-scripts and then press Enter. The
/etc/sysconfig/network-scripts becomes the working directory.
2 Type vi ifcfg-eth1 and then press Enter. The ifcfg-eth1 file opens for editing
using the vi text editor.