Cisco Multi-Stream CableCARD Module Guía De Instalación
Chapter 2 PKES Platform Installation
14
4034718 Rev B
3 Add the following data to the ifcfg-eth1 file:
DEVICE=eth1
BOOTPROTO=static
DHCPCLASS=
HWADDR=00:0E:0C:E5:F1:21
IPADDR=192.168.1.173
NETMASK=255.255.255.240
ONBOOT=yes
Important: The values used for IPADDR and NETMASK in the preceding
example are for illustration, only. Use the actual IP address and netmask of the
PKES in use on your system.
BOOTPROTO=static
DHCPCLASS=
HWADDR=00:0E:0C:E5:F1:21
IPADDR=192.168.1.173
NETMASK=255.255.255.240
ONBOOT=yes
Important: The values used for IPADDR and NETMASK in the preceding
example are for illustration, only. Use the actual IP address and netmask of the
PKES in use on your system.
4 Save the file and close the vi editor.
Configuring the Routing Information
Follow these instructions to configure the routing information for the PKES.
1 At the PKES, type cd /etc/sysconfig/network-scripts and then press Enter. The
1 At the PKES, type cd /etc/sysconfig/network-scripts and then press Enter. The
/etc/sysconfig/network-scripts directory becomes the working directory.
2 Type vi route-eth0 and then press Enter. The route-eth0 file opens for editing in
the vi text editor.
3 Add the following lines to the route-eth0 file:
GATEWAY0=[the IP address of the management router]
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
Example: When you are finished, the route-eth0 file should look similar to the
following example:
GATEWAY0=172.105.1.174
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
Example: When you are finished, the route-eth0 file should look similar to the
following example:
GATEWAY0=172.105.1.174
NETMASK0=0.0.0.0
ADDRESS0=0.0.0.0
4 Save the file and close the vi editor.
5 Type vi route-eth1 and then press Enter. The route-eth1 file opens for editing in
5 Type vi route-eth1 and then press Enter. The route-eth1 file opens for editing in
the vi text editor.