Cisco Headend Digital Broadband Delivery System Guía De Instalación
Chapter 2 Activate SBE
14
740223 Rev F
SBE Activation Day Two
On Day Two you will verify that DIS is Enabled using the checkDIS.ksh utility to
confirm all DHCTs are showing the DIS enable flag. Then you will check database
counts to ensure the type 8 EMMs count is increasing.
1 Are you logged into the DNCS as dncs user in the /dvs/dncs/bin directory?
1 Are you logged into the DNCS as dncs user in the /dvs/dncs/bin directory?
If yes, go to step 5.
If no, go to step 2.
2 Log on as dncs user. The password prompt appears.
3 Type the dncs user password and press Enter.
4 Type cd /dvs/dncs/bin and press Enter.
5 Run the checkDIS.ksh command to see if any DHCTs have DIS disabled.
3 Type the dncs user password and press Enter.
4 Type cd /dvs/dncs/bin and press Enter.
5 Run the checkDIS.ksh command to see if any DHCTs have DIS disabled.
Important: All DHCTs in your system should have DIS enabled. If you see any
DHCTs with DIS disabled, then your billing system could be sending DIS
disabled flags and you must contact the representative who handles your
account.
6 Run the checkDIS.ksh -c command to obtain two counts from the database.
Note: It may take several minutes to receive count results.
7 Record the database count results on a sheet of paper.
Note: The desired result of these tasks is to have the two database counts match
or for the first number to be larger than the second number by Day Five. You
must contact the representative who handles your account if you do not notice
progress from the last counts recorded on Day One.
Important: Once you have completed this procedure, wait 3 days and then go to
Important: Once you have completed this procedure, wait 3 days and then go to
SBE Activation Day Five (on page 15).