Cisco Headend Digital Broadband Delivery System Guía De Instalación
SBE Activation Day Five
740223 Rev F
15
SBE Activation Day Five
Important: Ensure you have waited 3 days since completing Day Two activities
before you begin Day Five activities.
On Day Five complete the following steps to check your DHCTs and database
On Day Five complete the following steps to check your DHCTs and database
counts.
1 Are you logged into the DNCS as dncs user in the /dvs/dncs/bin directory?
1 Are you logged into the DNCS as dncs user in the /dvs/dncs/bin directory?
If yes, go to step 5.
If no, go to step 2.
2 Log on as dncs user. The password prompt appears.
3 Type the dncs user password and press Enter.
4 Type cd /dvs/dncs/bin and press Enter.
5 Run the checkDIS.ksh command to see if any DHCTs have DIS disabled.
3 Type the dncs user password and press Enter.
4 Type cd /dvs/dncs/bin and press Enter.
5 Run the checkDIS.ksh command to see if any DHCTs have DIS disabled.
Important: All DHCTs in your system should have DIS enabled. If you see any
DHCTs with DIS disabled, then your billing system may be sending DIS disabled
flags. You must contact the representative who handles your account for
assistance.
6 Run the Doctor Report. In the report section titled Database Table Extents, check
to see if the number of extents on the EMM table is increasing.
Example: The following example shows typical Database Table Extents output.
Example: The following example shows typical Database Table Extents output.
Database Table
Extents
atm_connection
7
displaychannels
2
elementary_stream
5
elementtable
5
elementtosource
3
emm
1
filemoduleinfo
6
hct_profile
3
Result: It is normal if the EMM extents are not listed, or if the number is 5 or less.
If the number of extents on the EMM table is greater than 5, you must contact the
representative who handles your account for assistance.