Cisco Headend Digital Broadband Delivery System Guía De Instalación
SBE Activation Day Ten
740223 Rev F
17
SBE Activation Day Ten
Important: Ensure you have waited 5 days since completing Day Five activities
before you begin Day Ten activities.
On Day Ten complete the following steps to check your DHCTs and database counts
On Day Ten complete the following steps to check your DHCTs and database counts
again.
1 Are you logged into the DNCS as dncs user in the /dvs/dncs/bin directory?
1 Are you logged into the DNCS as dncs user in the /dvs/dncs/bin directory?
If yes, go to step 5.
If no, go to step 2.
2 Log on as dncs user. The password prompt appears.
3 Type the dncs user password and press Enter.
4 Type cd /dvs/dncs/bin and press Enter.
5 Run the checkDIS.ksh command to see if any DHCTs have DIS disabled:
3 Type the dncs user password and press Enter.
4 Type cd /dvs/dncs/bin and press Enter.
5 Run the checkDIS.ksh command to see if any DHCTs have DIS disabled:
Important: All DHCTs in your system should have DIS enabled. If you see any
DHCTs with DIS disabled, then your billing system may be sending DIS disabled
flags. You must contact the representative who handles your account for
assistance.
6 Run the Doctor Report. In the report section titled Database Table Extents, check
to see if the number of extents on the EMM table is increasing.
Example: The following example shows typical Database Table Extents output.
Example: The following example shows typical Database Table Extents output.
Database Table
Extents
atm_connection
7
displaychannels
2
elementary_stream
5
elementtable
5
elementtosource
3
emm
1
filemoduleinfo
6
hct_profile
3
Result: It is normal if the EMM extents are not listed, or if the number is 10 or
less. If necessary, contact the representative who handles your account for
assistance.