Cisco Headend Digital Broadband Delivery System Guía De Instalación
Logging on to the RNCS Servers
78-4021167-01 Rev D
3
Logging on to the RNCS Servers
These instructions are to be completed at the remote location and assume that the
RNCS servers have not yet been configured to serve as remote servers in the RNCS
design.
Complete the following steps to log on to the RNCS server.
1 Connect a laptop computer to the serial management port of the RNCS server.
2 Start the HyperTerminal application on the laptop and configure the application
1 Connect a laptop computer to the serial management port of the RNCS server.
2 Start the HyperTerminal application on the laptop and configure the application
with the following parameters:
Baud rate—9600
Data bits—8
Parity—none
Stop bit—1
Flow control—no
Note: The HyperTerminal application allows one computer to communicate with
another computer.
3 If necessary, power on the RNCS server.
4 Choose one of the following options:
4 Choose one of the following options:
If you are logging on to the Sun Fire V245 server, go to Configuring the
ALOM Port of the Sun Fire V245 Server (on page 3).
If you are logging on to the Sun Netra T5220 server, Configuring the ILOM
Port of the Sun Netra T5220 Server (on page 6).
Configuring the ALOM Port of the Sun Fire V245 Server
1 Type #. and then press Enter. One of the following results occurs:
The Login prompt appears.
The sc> prompt appears.
2 Did the Login prompt appear after you completed step 1?
If yes, go to step 3.
If no (the sc> prompt appeared), go to step 4.
3 If the Login prompt appeared after completing step 1, complete the following
steps.
a Type admin and then press Enter.
b Type the password (changeme) and then press Enter. The sc> prompt
a Type admin and then press Enter.
b Type the password (changeme) and then press Enter. The sc> prompt
appears.
4 Type break and then press Enter. The system interrupts the boot process of the
RNCS server.