Cisco Cisco StadiumVision Mobile Reporter Guía De Instalación
© 2011 Cisco Systems, Inc. All rights reserved
Page 8 of 71
with two mounting posts in front and two mounting posts in back. The mounting
posts in this type of rack are often adjustable so that you can position the rack-
mounted unit within the depth of the rack rather than flush-mount it with the front
of the rack. The rack-mounting hardware included with the SV Director Server is
suitable for most 19-inch equipment racks or telco-type frames.
posts in this type of rack are often adjustable so that you can position the rack-
mounted unit within the depth of the rack rather than flush-mount it with the front
of the rack. The rack-mounting hardware included with the SV Director Server is
suitable for most 19-inch equipment racks or telco-type frames.
Figure 13 shows an example of a 4-post (telco-type) equipment rack.
Figure 13. 4-Post Equipment Rack
Caution! Do not used an enclosed rack. Figure 13 (a) shows a free-standing,
enclosed rack with two mounting posts in the front. The SV Director Server
should not be installed in this type of enclosed rack, because it requires an
unobstructed flow of cooling air to maintain acceptable operating temperatures
for its internal components. Installing the server in any type of enclosed rack
enclosed rack with two mounting posts in the front. The SV Director Server
should not be installed in this type of enclosed rack, because it requires an
unobstructed flow of cooling air to maintain acceptable operating temperatures
for its internal components. Installing the server in any type of enclosed rack
—
even with the front and back doors removed
—could disrupt the airflow, trap heat
next to the server, and cause an over-temperature condition inside the server.
Rack Mounting Specifications
You can mid-mount the unit in a 19-inch (48.3-cm) equipment rack that conforms
to the 4-post rack specification (the inside width of the rack should be 17.5
inches [44.45 cm]). When installed in the rack, the unit requires two EIA 3.5-inch
(8.9-cm) vertical mounting spaces or 2 rack units (RU) for mounting.
to the 4-post rack specification (the inside width of the rack should be 17.5
inches [44.45 cm]). When installed in the rack, the unit requires two EIA 3.5-inch
(8.9-cm) vertical mounting spaces or 2 rack units (RU) for mounting.
Caution! Clearance in the front and rear of the SV Director Server must be
allowed for cooling air to be drawn in through the front and circulated through the
appliance and out the rear of the appliance.
allowed for cooling air to be drawn in through the front and circulated through the
appliance and out the rear of the appliance.
plan your equipment rack configuration: