Cisco Cisco StadiumVision Mobile Reporter Manual De Mantenimiento
© 2011 Cisco Systems, Inc. All rights reserved.
Page 21 of 94
Figure 13.
DMP Power Options
UTP Cable Runs
The DMP connects to a Cisco Connected Stadium network via a UTP cable
connection from the Ethernet RJ-45 port on the rear panel. A minimum quality cable
of Category 5 or higher Unshielded Twisted Pair (UTP) should be used for DMP
connections with the total cable length not to exceed the IEEE recommended 100
meters. Cable lengths exceeding 100 meters may cause instability when using
Power-Over-Ethernet (POE) to power the DMP 4310G.
connection from the Ethernet RJ-45 port on the rear panel. A minimum quality cable
of Category 5 or higher Unshielded Twisted Pair (UTP) should be used for DMP
connections with the total cable length not to exceed the IEEE recommended 100
meters. Cable lengths exceeding 100 meters may cause instability when using
Power-Over-Ethernet (POE) to power the DMP 4310G.
DMP to TV Connections
As shown in Figure 14, there are primarily three connections when connecting a
Cisco DMP to a TV: video, audio, and TV control. Audio is optional as it may not be
required at the TV location or it may be a component of the video stream carried
over the HDMI connection.
Cisco DMP to a TV: video, audio, and TV control. Audio is optional as it may not be
required at the TV location or it may be a component of the video stream carried
over the HDMI connection.