Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
Installing Accessories
The following section provides instructions for installing accessories into the GainMaker
Line Extender.
To Install Attenuator Pads
Complete the following steps to install the attenuator pads in the amplifier.
Note: For best results, follow this installation procedure exactly.
Note: For best results, follow this installation procedure exactly.
1
Begin this procedure with the housing open. Refer to To Open the Node Housing (on
page 15).
Note: These accessories can be installed without removing the cover.
Note: These accessories can be installed without removing the cover.
2
Install the pad(s) specified by the design print in the appropriate pad slot(s). For a
list of available accessory pad values and part numbers, see Technical Information
(on page 95).
Notes:
Be sure that all the pins on the attenuator pad bottom align with the pin holes in
the attenuator pad slot, allowing the attenuator pad to install flat against the
amplifier module.
The locations for attenuator pads are approximately the same for all GainMaker
Line Extender amplifiers. The illustration above shows a typical example.
The interstage pad is installed at the factory to set the operational gain of the
28
OL-31155-01