Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Attaching the Coaxial Connectors
21
Attaching the Coaxial Connectors
To Trim the Center Conductor
The 1.2 GHz GainMaker Amplifier requires pin-type connectors for all RF
connections.
connections.
Standard pin connectors, with pins extending 1.5 in. to 1.6 in. (3.8 cm to 4.1 cm) from
the connector shoulder, require no trimming. You must trim longer pins before
inserting them into the housing.
the connector shoulder, require no trimming. You must trim longer pins before
inserting them into the housing.
Complete the following steps to trim long pins.
1 Place the connector above the entry port so that it lines up with its installed
1 Place the connector above the entry port so that it lines up with its installed
position.
2 If the center conductor pin extends past the STRIP line on the housing, trim the
pin flush to the STRIP line.
The following diagram shows a visual guide of the center conductor trim length.
To Connect the Coaxial Cable Pin Connector to the Amplifier Housing
Complete the following steps to connect the coaxial cable pin connector to the
amplifier housing.
1 Begin this procedure with the amplifier housing open. Refer to To Open the
amplifier housing.
1 Begin this procedure with the amplifier housing open. Refer to To Open the
Amplifier Housing (on page 13).
2 If the center conductor pin extends beyond the STRIP line on the housing, trim
the pin with heavy-duty wire cutters.
3 Insert the appropriate coaxial connector into the housing at the desired housing
port. Tighten the connector nut according to the manufacturer’s specifications.