Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
22
4 Tighten the seizure screw from 2 ft-lb to 5 ft-lb (2.7 Nm to 6.8 Nm).
5 Repeat steps 2 through 4 for each RF port used.
6 Check for the presence of RF at an unused port.
5 Repeat steps 2 through 4 for each RF port used.
6 Check for the presence of RF at an unused port.
If RF is present, insert a 75 Ohm housing terminator into the port and tighten
per manufacturer instructions.
per manufacturer instructions.
If RF is not present, insert a housing plug into the port and tighten from 5 ft-lb
to 8 ft-lb (6.8 Nm to 10.8 Nm).
to 8 ft-lb (6.8 Nm to 10.8 Nm).
7 Proceed to Installing the Housing (on page 23).