Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Installing Accessories
29
Important: Install the amplifier module cover properly, or RF signal degradation
may result.
may result.
6 Install other options or accessories as desired, or proceed to Installing the
Amplifier Module (on page 33).
To Replace the Diplexer
Complete the following steps to install the diplexer in the amplifier.
1 Begin this procedure with the housing open. Refer to To Open the Amplifier
Housing (on page 13).
Note: This accessory can be installed without removing the amplifier cover.
Note: This accessory can be installed without removing the amplifier cover.
2 Remove the diplexer covers by removing the diplexer retainer screws using a
flat-head screwdriver or cross screwdriver.
3 Remove the four (4) diplexer using the plastic handle on the component.
4 Plug the new diplexers into the diplexer slots.
5 Tighten the screws on top of the diplexer from 10 in-lb to 12 in-lb.
4 Plug the new diplexers into the diplexer slots.
5 Tighten the screws on top of the diplexer from 10 in-lb to 12 in-lb.
6 Install other options or accessories as desired, or proceed to Installing the
Amplifier Module (on page 33).
To Replace the Low Pass Filter Trim (LPFT)
Complete the following steps to install the low pass filter trim in the amplifier.
1 Begin this procedure with the housing open. Refer to To Open the Amplifier
1 Begin this procedure with the housing open. Refer to To Open the Amplifier
Housing (on page 13).
2 Unscrew the four module retainer screws.